DIY Solar Charging Kit for Lithium Batteries – MPPT, BMS, Buck Converter, JST Cables – Compatible with IoT, Meshtastic, Raspberry Pi, ESP32, Arduino

Energy your subsequent electronics venture with this all-in-one photo voltaic charging package designed for secure and environment friendly use with Lithium Ion and Lithium Polymer batteries. Whether or not you are constructing a transportable sensor, a wi-fi gadget, or a solar-powered gadget, this package consists of the important elements to get began. Product Options All-in-One Equipment – Consists of 2 PeakMesh Li-Shield BMS modules, 2 MPPT photo voltaic charging boards, 2 DC-DC buck converters, and 4 JST PH2.0 cables (2 left-positive, 2 right-positive). Battery Safety Modules (BMS) – Forestall overcharging (cutoff at 4.25V) and over-discharging (cutoff at 2.9V) to increase battery life and guarantee security. MPPT Photo voltaic Charging Boards – Accepts 4.4–6.5V photo voltaic enter with a 4.2V output at 1A max. Optimized for five–6V photo voltaic panels and small electronics. DC-DC Buck Converters – Step down enter voltages from 5–30V to a steady 5V output. Helps as much as 3A with correct heatsinking. Perfect for DIY Tasks – Nice for Meshtastic radios, Pwnagotchi gadgets, Raspberry Pi programs, IoT sensors, wearable electronics, GPS trackers, and extra. Technical Specs Li-Shield BMS Module Dimensions: 7 × 29 × 8 mm Load: 2A typical, 4–5A with testing Brief Circuit Safety: 30–40A Overcurrent Safety: 7–10A MPPT Charger Board (SD05CRMA) Enter Voltage: 4.4–6.5V Output: 4.2V charging voltage, 1A max Dimensions: 10.3 × 18.3 × 3 mm DC-DC Converter Enter: 5–30V Output: 5V fastened Output Present: 1.5A (no heatsink), 3A max Dimensions: 17.6 × 12.3 × 4 mm Functions Good for solar-powered electronics tasks together with: Wi-fi sensor networks Transportable consoles and gaming gadgets Dwelling automation programs Photo voltaic-charged ESP32 builds Meshtastic and LoRa nodes GPS trackers and safety cams Arduino and microcontroller moveable gadgets Wearable Computing
Consists of safety modules, MPPT chargers, DC-DC Buck converters, and JST connector cables
Li-Shield module prevents battery injury from overcharge and deep discharge
MPPT boards optimize photo voltaic charging effectivity with 4.2 volt output and 1 amp present
Perfect for wearables, Raspberry Pi, GPS trackers, wi-fi sensors, and prototypes
Designed for DIY electronics together with Meshtastic radios, Microcontrollers, and IoT tasks. Something small and photo voltaic powered
Consists of 4 JST PH2.0 cables for quick connections to RAK boards and different gadgets